Tuesday, 07 September 2010
Drax Tuning Innovation is specialised in tuning cars
equiped with standalone ecu's , piggyback's and chips.
We are known for tuning cars in the motorsport industry since the past decade.
We specialize in tuning Haltech , Motec,  E-Manage , S/Vafc , Honda Drax Chip ,
Mitsubishi Drax Chip , and lastly assemble & tune Megasquirts.
Coming Soon....  Megasquirt 3.
Mazda Tuning PDF Print E-mail

Image

We, Drax Tuning innovation have done a lot of Mazda Tuning on Electronic Control Unit (ECU) and Engine modifications.
We have few projects which gives surprising horsepower and torque gain with simple tweak on the ECU software and as
simple as changing a drop In Air Filter.
 
After extensive testings, we are confident that we could serve you better on Mazda Tuning. We would like to show and
share with you our Expertise, Knowledge, Skill and Informations. We could now serve you with our ECU tuning programme
and software upgrade which will give an enhance driving experience.
 
These days, car manufacturers has overcome the technology on safety precautious for all driver in the world. CAN-Bus
and Drive By Wire (DBW) technology come into play for safety purposes.
 
Mazda are very limited in performance parts. This is due to the Mazda Engineers has design their motor in optimum
performance for normal consumer but why its so lack in performance? The answer is, the ECU parameters has hide
most of the performance capabilities in the ECU Programme! So here are some answers to your doubts!!!!

 Image

Frequently Q&A:

-         Will my car go any faster after Drax Tuning Innovation tuning ?

In most cases your car will achieve a higher top speed.

Standard car are equipped with a rev and speed limiter. (most modern car´s have) Drax Tuning Innovation
have in some cases increased the rev and speed limit to reach a higher top speed.
 

-         What about the fuel consumption after Drax

       Tuning Innovation tuning ?

Optimizing the software in the ECU will provide increased power and less fuel consumtion in general.
 

-         What about "Wear and Tear" ?

Drax Tuning Innovation tuning doesn't affect "wear and tear" at all.
It's how you drive and look after your car (service intervals etc) that affect the conditions of your vehicle.

-         Can my garage & mechanic see that my car

       has been tuned ?

Your local garage does not normally have the skill or equipment to read files from the ECU, to do this they have to send
the ECU back to the vehicle manufacturer.
 
 We never encourage the Drax Tuning Innovation users to cheat their garage, car salesman etc. that the car is tuned with
our software programme. We think instead it's better to tell the truth. Our Software Programme doesn't in any way affect
servicing or fault diagnosis.
 

 -         Can the dealer see that my car is modified?

There is no removal or addition of any hardware so there are no physical indications that the car had been modified. Engine
electronics communicate exactly as original as if the software is using 'Stock' ecu. most current diagnostic equipments cannot
detect any difference. If however the car is left in performance mode it becomes obvious that its not standard when someone
drives the car, this could be confirmed by data logging requested boost values. As there are no permanent changes to the
ECU the factory original code can simply be reloaded at any time.
 

-         How fast will my car accelerate from 0-100 Km/h

       after tuning with Drax Tuning Innovation?

The reduced time for acceleration and car performance is dependent on the effect and gain in torque. On several models
Drax Tuning Innovation have measured the acceleration time before and after tuning and the results are published on the
specific car dyno results.

Image

 
 
< Prev   Next >
[ Back ]